Hole reaming

Issues, solutions, helpful hints, shortcuts, tools, etc
jbobc
Posts: 2
Joined: 03 May 2009, 16:47
Anti-spam question: 4
Are you a spammer: No

Hole reaming

Postby jbobc » 30 May 2017, 18:31

I bought a 1/2" reamer in anticipation of reaming the suspension rod end holes. I am also planning on following Kurts idea for using SS washers for both wear and increased bearing area. In my experience on other projects, drilling SS is hard on drill bits. What should I expect to see as far as using my reamer on the SS augmented rod end holes? Presuming I pre drill the holes to 15/32" prior to reaming.

Midlana1
Site Admin
Posts: 2769
Joined: 19 Dec 2008, 16:44
Anti-spam question: 4
Are you a spammer: No
Location: Southern California

Re: Hole reaming

Postby Midlana1 » 30 May 2017, 22:07

My average cost 1/2" reamer still works great so I think you'll be fine.


Return to “General Build Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest